This installation guide is applicable to any kind of fence. We have used a metal tubular fence for our demonstration, but the same basic steps apply to any kind of fence including...
Wood Picket
Wood Slat
Metal Tubular
Metal Slat
Metal Sheet
Brush*
PVC
Emu Wire*
* with extra supporting frame to bolt on to.
Equipment Needed
Drill with Hex head attachment, Metal or wood drill bit
Self tapping Tek Screws
Angle grinder or hacksaw
Metal file or sander
Spray paint in colour of fence
Rivet gun
Rivets
Letterbox Location
Firstly, the location of your letterbox is important. Australia Post regulates that the slot should be somewhere between 900 and 1200mm from the ground. Posties should have clear and unhindered access to the slot and it should ideally be located as close to the footpath as possible.
Steps
1. Once you’ve chosen your location, use self tapping Tek screws to bolt rear flange to back of fence. It is best to use at least 3-4 screws on each the top and the bottom row.
2. Using an angle grinder, hacksaw or any other appropriate metal or wood cutting tool, cut out the portion of the fence inside the rear brace frame.
3. Use a file for metal or sander for wood, to smooth out the edges that were cut.
4. Apply a coat of paint to protect the exposed metal from corrosion or wood from rotting.
5. Slide the letterbox in through the front of the fence and drill two holes through both the flange flaps and the box. One on each of the corners of the flaps, starting with the top.
6. Use a rivet gun to pop rivet the flange to the box.
7. Repeat with the bottom of the box.
Done!
This provides a seamless and aesthetic letterbox installation, with no bolts, screws or rivets showing on the front of the box. For more information on fence letterboxes, check out our other blogs here.
0 Comments
There are no comments yet. Be the first one to post one!